We bought old Maho.
After moving, constants lost, we replaced battery on MH500W from 1991, drivers indramat ,with toolchanger.
We introduced constants line by line from a list joigned to machine.
We had Y and Z axis inversion, we solved this problem.
We had machine start with G18, we solved.(CM 11)
X ref point is X-500mm approx really on table, but display write +500mm, X- and X+ keypads in phase with table but X- is on right hand and X+ left hand.
We'd like to reverse X axis, how many constant have to change ? Which ones ?
Thanks a lot