523,794 active members*
2,065 visitors online*
Register for free
Login
IndustryArena Forum > Machine Controllers Software and Solutions > Roeders > who gets the TCM down to less than 30 seconds
Results 1 to 2 of 2
  1. #1
    To all users of Roeder's controller!

    Our versions 3.41 and 3.60 are preset with 16 measuring points for the "auto step edge" (automatic steps to measure the cutter corner radius).
    Since we do not want to use the measurement for the wear detection but for the locating of falsely substituted cutters, each tool has to go through the measurement which takes at least one minute. Now we have set the parameters from 16 steps to 8 and to 4 and sometimes even to 3 but it still takes 30-45 seconds.
    Who here has already had experience?

  2. #2
    Hello Take it easy
    What do you write into your commando file?

    Regards
    Elmoh

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •