Hi people
I have a little problem!
I’ve had a new hard disk for 2 weeks and now not everything works as it has to.
During proceeding I can see only the REF value… where I can set that I would also see the IS value? As on the picture
And diameter input doesn’t work for the centering cycle…
Isn’t it enough if I declare the point angle (T-angle) in the WZT?
PS: controller 530i
Thread: IS/REF
Results 1 to 4 of 4
-
12-30-2008, 02:57 PM #1
- Join Date
- Oct 2008
- Posts
- 123
-
12-30-2008, 06:36 PM #2
CNC-Arena Award Winner 2011
- Join Date
- Oct 2006
- Posts
- 3342
You just have to press MOD in the manual mode. Then you’ll get this picture.
Then set one of the both. I think the second one
Regards, general<b><!--sizeo:5--><span style="font-size:18pt;line-height:100%"><!--/sizeo-->Gruß General<!--sizec--></span><!--/sizec--></b><br /><br /><br /><br /><!--sizeo:3--><span style="font-size:12pt;line-height:100%"><!--/sizeo--><b>Fräser sind Halbgötter in Blau.<br />Denn sie lassen durch Zerstörung Neues entstehen!!!!</b><!--sizec--></span><!--/sizec--><br /><br /><br /><!--sizeo:2--><span style="font-size:10pt;line-height:100%"><!--/sizeo--><u>Werbung in eigener Sache:</u><!--sizec--></span><!--/sizec--><br /><i><!--sizeo:2--><span style="font-size:10pt;line-height:100%"><!--/sizeo-->Enter the Matrix an feel the Moment "<u>www.pixxelmatrix.de</u>"<!--sizec--></span><!--/sizec--></i>
-
12-30-2008, 07:47 PM #3
- Join Date
- Oct 2008
- Posts
- 123
Thanks
-
12-30-2008, 08:24 PM #4Paranuit Guest
Hello
A little addition
Display 1 left monitor, display 2 according to that right.
Reply With Quote
Posting Permissions
