[dodo3]

Hello
It’s is possible to set up the programming station like it is on a machine?
I mean the whole kinematics and the soft keys.

I have the backup of the machine.
Unfortunately the machine manufacturer don’t like to give it out as it is on the training courses

Kind regards
Dodo

[cgTNC]

I have the backup of the machine.

Is the backup only from the TNC folder or of the PLC?
In the PLC you can find a folder which is called kinematics or a similar name...
You have to play it in with the TNC Remo in the demo version.

Also adjust the OEM.SYS in the row KINEMATICS according to the backup.

Regards

cgTNC

[CNCFanatiker]

Hello
It’s is possible to set up the programming station like it is on a machine?

Hello dodo3
What’s included in your backup? As cgTNC already wrote, you need more than just a back up of the system files. An update of the complete PLC would be optimal

However an interesting topic, what about we create a little tutorial to adjust the programming station.

Let’s see where we reach out limits

Let’s make a check list of the points that need to be considered when adjusting the work station.

We will need:

1. Adjust depending on the software version (identical software version on PC and on machine)
2. original PLC update of the source- machine
3. please add

What needs to be modified:
1. Kinematics
2. M-commands ( possible manufacture specific)
3. MP adjustments and user parameters
4. user macros
5. please add

[schwindl]

Cycles, that will be tricky without cycle design
Travel areas
Tool.t

[dodo3]

That sounds very good already.
The backup is 175MB and it can be opened with TNCremo.
In there are 2064 files.

Kind regards Dodo3