[arenamember]

Hello

Thank you for entering in my post

I can't understand why but suddenly the diameter I put on the tool table don't longer match with the diameter on the graphic when I test the program

I did try to put even zero as diameter and it makes the same graphic as before

I am going mad, may you please tell me what happened

Thank you in advance for your help

[CNCFanatiker]

Hello

Thank you for entering in my post

I can't understand why but suddenly the diameter I put on the tool table don't longer match with the diameter on the graphic when I test the program

I did try to put even zero as diameter and it makes the same graphic as before

I am going mad, may you please tell me what happened

Thank you in advance for your help

Hello arenamember,

make sure that the same tool table as well as in automatic mode also is activated in simulation.
(look for status "M" & "S" of tool.t in the programm management)