[Sit22]

Hello

Does anyone already have a PDF manual for the new Siemens Operate surface?
I am interested in the thread cycle CYCLE 84.

Kind regards
Sit22

[hapo]

CYCLE84 has nothing to do with the operate surface ... at least not directly.
The masks of the cycles are only animated graphics as far as I know, compared to ShopTurn.
Look under the 828D at http://www.automation.siemens.com/doconweb/

[InTex]

Hello Sit22

What's wrong with the cycle? Does it make the problems?
I installed the V4.4 yesterday. Your problem would be interesting.
It does not change, even when one has a different surface.
The reverse translation is actually enough information.

[Sit22]

I must write a PP and the customer can choose something additionally
Siemens Operate
CYCLE84 (10,0,2, 12,0,3, 0.8,0,400,400,0,1,0,2,4,1.4, "ISO_METRIC", "M5", 1.1001001)
the rear part is somehow new 1,0,2,4,1.4, "ISO_METRIC", "M5", 1.1001001)
Siemens Advance
CYCLE84 (10.0, 2, 12, 0, 3, 0.8,, 400, 400, 3,1,0, 0, 0, 0)used to be always enough in the past.

[InTex]

Hello

The rear section is just an addition in Operate. What’s already valid in Shop Turn / Mill with the direct fit input is here also possible with a direct input of a standard thread.
You can select it under table and then press it with the select button

That should have no effect even for the creation of a PP.
The cycle will be capable to run even without this addition.

[Sit22]

Ok thank you for that information!

Have a nice weekend