Hello
My problem: I have to lathe 2 different diameters.
I’ve tried to set 2 magazines with one tool, but the controller ignores the second magazine.
T1 D1 (for small one)
T1 D2 (for big one)
D2 is ignored.
Has anyone done such a thing?
Hello
My problem: I have to lathe 2 different diameters.
I’ve tried to set 2 magazines with one tool, but the controller ignores the second magazine.
T1 D1 (for small one)
T1 D2 (for big one)
D2 is ignored.
Has anyone done such a thing?
With my 820M it works without any problems. Call a new correction number S…. enter M03/04 and it works. The current D-number is shown in the general view in the auto mode, tool correction magazine as well. Just look
Hello Marvin,
Try that with T1 D12 or higher. In our case it works with all machines, with old ones as well. Otherwise there’s something wrong with the controller.
Regards, Walter
Es geht nicht nebeneinander, schon gar nicht gegeneinander,<br>es geht nur <b>miteinander</b>.
Thanks a lot,
It works with the numbers