hello
I’ve got a question about thread cutting without shim plate.
Machine is Chiron FZ22 with Sinumerik 810M GA3.
What do I need therefore?
A special program?
Or do I have to change parameters?
I’ll appreciate any help.
Horst
hello
I’ve got a question about thread cutting without shim plate.
Machine is Chiron FZ22 with Sinumerik 810M GA3.
What do I need therefore?
A special program?
Or do I have to change parameters?
I’ll appreciate any help.
Horst
Hello Horst2
If you have the cycle G331/G332 at your machine, then you have everything you need.
Greetings
InTex
Eine Schraube ohne Gewinde ist ein Nagel<br /><br />Grüsse aus dem Harz - InTex<br />
Hello InTex
I’ll check tomorrow if the cycle is present.
I hope it’s stored under cycles.
If it’s not, where could I get it?
Greetings
Horst2
@Horst2Hello InTex
I’ll check tomorrow if the cycle is present.
I hope it’s stored under cycles.
If it’s not, where could I get it?
Greetings
Horst2
I believe you have the cycle because a cycle for thread boring has to be present even in a basic packet.
Otherwise you’ll have to buy it at Siemens.
Regards
InTex
Eine Schraube ohne Gewinde ist ein Nagel<br /><br />Grüsse aus dem Harz - InTex<br />