584,871 active members*
5,327 visitors online*
Register for free
Login
Results 1 to 4 of 4
  1. #1
    Join Date
    Jan 2008
    Posts
    48
    hello
    I’ve got a question about thread cutting without shim plate.

    Machine is Chiron FZ22 with Sinumerik 810M GA3.

    What do I need therefore?

    A special program?

    Or do I have to change parameters?

    I’ll appreciate any help.

    Horst

  2. #2
    Hello Horst2

    If you have the cycle G331/G332 at your machine, then you have everything you need.

    Greetings
    InTex
    Eine Schraube ohne Gewinde ist ein Nagel<br /><br />Grüsse aus dem Harz - InTex<br />

  3. #3
    Join Date
    Jan 2008
    Posts
    48
    Hello InTex

    I’ll check tomorrow if the cycle is present.

    I hope it’s stored under cycles.

    If it’s not, where could I get it?

    Greetings
    Horst2

  4. #4
    Hello InTex

    I’ll check tomorrow if the cycle is present.

    I hope it’s stored under cycles.

    If it’s not, where could I get it?

    Greetings
    Horst2
    @Horst2

    I believe you have the cycle because a cycle for thread boring has to be present even in a basic packet.

    Otherwise you’ll have to buy it at Siemens.

    Regards
    InTex
    Eine Schraube ohne Gewinde ist ein Nagel<br /><br />Grüsse aus dem Harz - InTex<br />

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •