Hello, I have a new machine without an opposed spindle. Log gripper in the revolver. I want to pull with the resolver and if applicable turn the C axle.
My current solution is that is use start- up and shutdown and straight paths as well as M36 and M37. I just add it behind the program.
At the moment I am missing the turning of the c axle to for example 75°.
I haven’t found the function yet.
Generally I don’t like it!
For the cutting there is a nice cycle ( At Hainenhain I used to work always with g commands)
There should be such a cycle to pull.
My better solution would be with a subprogram. But I never done that with Shopturn.
There must be several parameters handed over:
Lengh of the part, width of Groove, Cutting length with plan turning, with or without c axle
How can I do that with parameters and how can I come back form the subprogram (maybe with return)
Please help me out, I am writing all our programs on the machine and I am the only one that know a little bit about this area. All other machines have Haidenhein with data pilot.
Thanks a lot