[musikwelt080977]

Hello everybody,
I have a spinner machine with Shopturn V.7.20…

I tried to mill a longitudinal slot on the rear side but I had several problems:
First of all, I couldn’t construct an angle deburrer in Shopturn and the control didn’t allow
a travel path in the cycle after n+.

So my question is how trick the controller so that I can define a angle deburrer and then debur on the rear side. Does that only work with G code - if so please give me a solution.

Would be very grateful for your help

Greetings from Barnim

[EddiKett]

[

Hello everybody,
I have a spinner machine with Shopturn V.7.20…

I tried to mill a longitudinal slot on the rear side but I had several problems:
First of all, I couldn’t construct an angle deburrer in Shopturn and the control didn’t allow
a travel path in the cycle after n+.

So my question is how trick the controller so that I can define a angle deburrer and then debur on the rear side. Does that only work with G code - if so please give me a solution.

Would be very grateful for your help

Greetings from Barnim

Have you ever tried to program it freely- not in a cycle ?? Also you could state a different milling machine instead of an angular mill- but then use you angular mill and write your cycle according to it.

Greetings
enrico

[musikwelt080977]

Have you ever tried to program it freely- not in a cycle ?? Also you could state a different milling machine instead of an angular mill- but then use you angular mill and write your cycle according to it.

Greetings
enrico

Hallo enrico,

I am not so familiar with the transmit programming in Shopturn. Also the machine has no proper y axle what I believe makes everything even more complicated.

Just in case I need it would you be able to show me the process in G code?

Would be very thankful!
Greetings from Barnim