584,846 active members*
4,124 visitors online*
Register for free
Login
Results 1 to 2 of 2
  1. #1
    Hello everybody
    I get the following error message when I try to carry out a countersinking operation ‘countersink tool with the flat cone point not allowed’
    The tool is declared and displayed correctly in the tool view- so with a flat cone point!
    What am I doing wrong?

    I hope you understand what I described.

    Regards Dw

  2. #2
    Join Date
    Jun 2005
    Posts
    7
    Hello
    We still have NX6 and it doesn’t work either with that version. It’s best to set the cone point diameter to zero. Then it lifts off a bit too much but it still drives.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •