[ichmts]

Hello
I’m about to despair. Here is the contour:

L10=32,5
G1 X0 YL10
G3 P2.45 A[L10+0.5] // IT’S SOMETHING WRONG HERE, IF THIS LINE IS COMMENTED OUT, THERE ISN’T ANY ERROR
G2 X13.528 Y[L10-5.063] R30.591
G1 X21.342 Y[L10-8.782]
G3 X24.619 Y[L10-11.283] R10

What can be wrong there?
The contour has to look this way:
[attachment=4949:kontur2.jpg]

could anyone help me?

[ichmts]

Hello
I’m about to despair. Here is the contour:

L10=32,5
G1 X0 YL10
G3 P2.45 A[L10+0.5] // IT’S SOMETHING WRONG HERE, IF THIS LINE IS COMMENTED OUT, THERE ISN’T ANY ERROR
G2 X13.528 Y[L10-5.063] R30.591
G1 X21.342 Y[L10-8.782]
G3 X24.619 Y[L10-11.283] R10

What can be wrong there?
The contour has to look this way:
[attachment=4949:kontur2.jpg]

could anyone help me?

OK, done it.
R30.591 -> 30.592 and everything works.
Error messages of the Traub could be better!
Well, I want too much from a machine of this age.

[gekufi]

What can be wrong there?

Error messages of the Traub could be better!
Well, I want too much from a machine of this age.

Hello

It would be better if one would also write the error message. Then other members could help faster and exacter. Because due to the message of the controller it’s possible to locate the problem.

Greetings, Gerd

[ichmts]

Hello

It would be better if one would also write the error message. Then other members could help faster and exacter. Because due to the message of the controller it’s possible to locate the problem.

Greetings, Gerd

The error was like: G01 needs X Y A parameters.