585,555 active members*
3,401 visitors online*
Register for free
Login

Thread: Spindle fit

Results 1 to 3 of 3
  1. 07-03-2008, 09:40 AM #1
    kickinger
    kickinger is offline Member
    Join Date
    Nov 2004
    Posts
    160
    Hello,

    I had spindle damage at my milling cutter. I saw that the borehole where the spindle had been picked up was not clean, ca, 1/5 of the hole was not clean.
    May it be concerned with the spindle damage?

    Regards
    Kiki
    HAAS VF7 - BJ2008<br />HAAS ST20<br />HAAS ST10 mit Stangenlader<br />HAAS Mikron VCE1000<br />EMCO 365<br /><br />www.KDC-Technik.at
    Reply With Quote Reply With Quote
  2. 07-18-2008, 08:58 AM #2
    spindelservice
    spindelservice is offline
    Join Date
    Jun 2006
    Posts
    53
    Hello!

    What milling cutter is it?
    Do you mean the cylindrical case where you insert the spindle?
    Is it integrated horizontally or vertically?
    Gruß,<br />spindelservice<br />
    Reply With Quote Reply With Quote
  3. 07-18-2008, 09:12 AM #3
    uli12us
    uli12us is offline Junior Member
    Join Date
    Apr 2002
    Posts
    5003
    If I interpret correctly that what you wrote, it isn’t concerned with any spindle damage.
    I think a rough part was cast too large, so that it couldn’t go out completely.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules