Hi I'm using USB motion card -
http://www.ebay.com/itm/CNC-USB-Smooth-Stepper-For-Mach3- Smooth-Stepper-Motion-Control- With-Terminals-/181442354187? pt=UK_BOI_Industrial_ Automation_Control_ET&hash= item2a3ece9c0b
with MACH3. after typing G-code in the MIDI box, the machine start work, but MACH3 writes me this message:
Move, Give up Sync![Movement Info]
I have two axis (X,Y) and my axis are not sync. I don't know what can it be.
I'm using servo motors with the controllers set up to Stepper Emulation Mode (means it reads the step/dir as it was a stepper controller). when I check the servo monitor - it has no error, means that it goes the same amount of steps that it gets from the signal coming out of MACH3.
This error above is very suspected... does anyone know what does this error mean?
I'm working with unlicensed copy of MACH3 (jest haven't purchased licensed yet). could it effect?
thanks a lot,
Liron