[SnowmanSD]

Is there someone that can help me with the process of reloading the software on an Arrow 500 with a Control Techniques controller? I will need the files and the instructions. I really appreciate the help.

[meckardt55]

Send me an e-mail and I will send you what we have on this control.

Mike cncmachineservices (dot) com

[honestjohns]

I am having the same problems. I was wondering if u could forward me the files you got from Mike

[meckardt55]

Send us an e-mail for the info [email protected]

[sji]

Dear Friend.
Solve your problem?

Jeferson

[SnowmanSD]

Dear Friend.
Solve your problem?

Jeferson

Jeferson,
Yes and no, I reloaded the software, but it is still extremely slow. I found that when it gets cold in my garage, it processes data faster. I think I have a controller issue. So if you have any info on that, I would appreciate it

[sji]

ok,


Good'm new to Arrow 500 and I'm picking up, but the little that I'm watching most of the problems as well as what I had been feeding the wrong transformer is correct the power of its Arrow?

[cjhurt]

Hi i hope you can help me i have a same problem with the process of reloading the software on an Arrow 500 with a Control Techniques controller?
I will need the files and the instructions. I hope you can help me thanks

[Daniel Algarve]

Hi snowmanSD

Did you solve the problem of reloading the software? I have the same problem. Can you help me please.
Best regards.

Daniel