[G91guy]

I have a Hitachi Seiki VM40III with a Yasnac control. Lately the machine will stop running and throw the alarm "3481 YE-NET I/O ERROR (NO.1)" No way to get the machine going again other then to shut down and restart. Has anyone seen this before, and more importantly what was done to correct it. Any help much appreciated as I am a small shop.

[shas595]

Hello,

I replied on practicalmachinist but I'll reply here too just in case

Does that VM have the Yasnac J300 Control? Can you tell me a little bit about the history of the machine? How long has it been happening, is it always at the same time, etc.

John

[MAYELO]

Hello,

I replied on practicalmachinist but I'll reply here too just in case

Does that VM have the Yasnac J300 Control? Can you tell me a little bit about the history of the machine? How long has it been happening, is it always at the same time, etc.

John

Hello,


I have a Hitachi Seiki Seicos Fanuc 16 lathe.

Do you have a procedure to update the memory?

[shas595]

Hello,


I have a Hitachi Seiki Seicos Fanuc 16 lathe.

Do you have a procedure to update the memory?

Send me a PM with your end and I’ll assist


Sent from my iPhone using Tapatalk