I have the THC300 and I am running Mach 2.I get the tip voltage read-out when I manualy fire the torch.The ark O.K. led comes on and the computer ark ok comes on.But when I try to fire the torch with an M3 command it does not fire ,if I click fire torch in Mach2 nothing happens.
My question is Do you think I do not have it configured correctly ,because I don't know where the pins are for torch on and torch off.
Thread: Cannot get my torch to fire?
Results 1 to 2 of 2
-
08-27-2006, 04:24 AM #1
Registered
- Join Date
- Oct 2004
- Posts
- 85
Cannot get my torch to fire?
-
08-27-2006, 03:45 PM #2
Gold Member
- Join Date
- Jul 2005
- Posts
- 2415
Without looking up the specs I think the Torch relay on the THC Sensor Card fires from port 2 pin 1. It uses Output1 (M03/M05) to fire the torch. You should see Output1 in MACH go active. Make sure it's setup in Ports & Pins to Port 2 pin 1.
Support for THC300, THC500 and MP1000-THC at CandCNCSupport yahoo groups.
Reply With Quote
Posting Permissions
