[stovall]

We have 2 Mazak VNC510C's & due to the type of parts that we manufacture we only need to run our chip conveyors a couple of times per day to avoid coolant loss. Does anyone know what parameters to change in the Fusion control to disable the conveyors running except when the operator manually presses the button to turn the augers & conveyor on? I found the attached pdf file on another thread, but am unsure if it applies to my control.Thanks for any help you could provide!

[stovall]

I actually found my own answer in the paperwork in the electrical cabinet of our machines. The parameter for our machines was RB18 bit 7, however it looks like different conveyors may use different parameters. I can in no way recommend that you try using this info. Check the back of your machines for the paperwork on the conveyor & the BOM where I found ours, or contact Mazak service before making ANY parameter changes.