How can I change the pierce delay in Mach 2. It seems to be sitting there too long.
Thread: pierce delay in Mach 2 ?
Results 1 to 3 of 3
-
08-31-2006, 03:01 PM #1
Registered
- Join Date
- Oct 2004
- Posts
- 85
pierce delay in Mach 2 ?
-
09-02-2006, 04:50 PM #2
Gold Member
- Join Date
- Jul 2005
- Posts
- 2415
Open MACH2. Go to Ports & Pins/Spindle Output (may be in another spot in MACH2, haven't run it in over a year). Turn off any Spin-up spin down delay.
Let the Arc Good signal set the pierce delay.
-
11-13-2011, 01:58 PM #3
Registered
- Join Date
- Nov 2011
- Posts
- 0
hi redline i had same problem, [was sore on tips], had turned off any spin up/down delays still no good so with some long evenings i found in general configuration look for g04 dwell in ms and click it off or switch it off it worked fine after that..
Reply With Quote
Posting Permissions
