Q: If the plasma cutter stop working because of low air pressure, is there any way for the CNC cutting machine to stop working when plasma stop working.

A: Yes , there is ARC feedback sensor in SteelTailor portable CNC cutting machine, Please set this parameter to 1 to enable ARC FEEDBACK. Once this is enable the CNC will stop automatically if the plasma ignition fails.
Go to SETUP[F4]-----PLASMA[F4]----- ARC FEEDBACK(0/1) set this to 1 to enable ARC feedback .


Attachment 250858

Get technical support from SteelTailor,pls visit:
Forum - Powered by Discuz!