[J10bucks]

I was told to type in G0 G90 G53 X-17 at end of program and this doesn't work. It's like something is overwriting it and the table just stays in the X position that the program finished at. Anyone have a idea whats going on?

[HYPERTUNE]

17 or 17.?

[J10bucks]

that was it, thanks. I figure it was something dumb that I was missing

[mactec54]

J10bucks

Apart from the dot missing, you may be able to have a much shorter piece of code

What are the lines of code that are before this move, if you have a G0 move for say the Z axes move it can be as simple as G53X17.

So it would be like this

G80G0Z3. (The G80 would only be there if you have just ended/done a canned cycle)
M9
M5
G53X17. (you can include a Y axes move in this line as well if you need it)
M30

[J10bucks]

that works, thanks for all the help

[underthetire]

If this is something you do a lot of, you can also set up the G30 second ref return to park the table, or assign the M30 to a macro to park the table.