[mayelo82]

Good day


The procedure was performed for calibration

without wire

VOUT and GND = 60mV
TENSENS and GND = 300mV

As indicated in the procedure

And turn on the machine. H00207 shows alarm. Tension abnormal press ENT to continue

And after a few seconds. E00180 shows alarm. Excess discharge time (SH) press ACK


Thanks for your time

[mayelo82]

Good day


The procedure was performed for calibration

without wire

VOUT and GND = 60mV
TENSENS and GND = 300mV

As indicated in the procedure

And turn on the machine. H00207 shows alarm. Tension abnormal press ENT to continue

And after a few seconds. E00180 shows alarm. Excess discharge time (SH) press ACK


Thanks for your time

When I turn on the machine is servo drive MSDA013D1A. marks (ERROR 14 Overcurrent)

could this be the cause of the failure of the tension wire

[Chan6946]

Having problem with condition 777 showing short-circuit been told to change the fuse no clue where the fuse is any help will be greatly appreciated