I'm retrofitting a Sabre 500, and all of the original control parts (850sx control, io rack, fanuc 3 axis servo drive, fanuc spindle drive) are working and available. If anyone needs control parts, please pm me
I'm retrofitting a Sabre 500, and all of the original control parts (850sx control, io rack, fanuc 3 axis servo drive, fanuc spindle drive) are working and available. If anyone needs control parts, please pm me
Ian
Curious about your choice in retrofit components. Will you please elaborate?
Arrow 1000 w A2100 GibbsCam
Miller Dynasty SD
I'm doing a LinuxCNC retrofit. Keeping the stock Fanuc model 5 motors, which drives I use is sort of up in the air; I have some parker gemini drives but it turns out they are less useful than I'd hoped. I have some AMC sinusoidal drives bought and on the way, but the ones I ordered are a bit too small.
Spindle will be run by a 25hp hitachi WJ200 VFD.
Interface hardware is Mesa 7i77.
Ian