[titoniks]

Hi all, my first post here, sorry for my english :stickpoke

in near future i'll buy a mill similar to IH mill, in Italy it's name is T044.

Actually i'm organazing my garage (again and again and again), i need the measures of the table plus travel (x axis) in order to build the right workbench

Hope in a reply

Tito

[lakeside]

most workbench are 32" hight (812.8 mm) you can make it as long and wide as you want and Welcome to the zone

[llino]

Ciao Tito,

Devi scusare il mi italiano...

Quale distanza vuoi?
Dal base tra il tavolo, o
la distanza da la sinistra parte dal tavolo quando il tavolo e' al sinistra tra la destra parte dal tavolo quando la tavolo e' al destra - Larghezza massimo? Il secondo depende dal larghezza del tavolo.

Or in English...
Are you looking for the height from the base to the table or the maximum width including table motion. The second one depends on the with of the table. The machine available in Italy may have a different size table than the IH model.

ciao

lino

[lakeside]

lino
Welcome to the zone

[titoniks]

thank you for reply,

llino you wrote in very good italian, i'm looking for the maximum width including table motion

you are right, at the moment the table of mill on sale in Italy is 31.5" wide instead of 39.5" IH mill, but there are the possibility to import a version with the same size

Tito

[llino]

Tito,

On my IH mill, I measure 86.5" from tip of hand wheel to tip of hand wheel including full table travel.


ciao

lino

[titoniks]

mmm..., 86.5" are too much for my garage

i really need 20" of travel not 30" as IH mill

ok, thank you for fast reply, probably i'll buy the ZAY7045 with the table wide enough for my needs

but...

within december i must complete my router, 'cause near my house the money don't grow on the tree

Tito