585,591 active members*
2,947 visitors online*
Register for free
Login
IndustryArena Forum > CAM Software > Mastercam > Plunge mill pocket

Thread: Plunge mill pocket

Results 1 to 2 of 2
  1. 11-06-2014, 06:13 PM #1
    guyjr
    guyjr is offline Registered
    Join Date
    Nov 2014
    Posts
    3

    Plunge mill pocket

    I'm trying to plunge mill a pocket using mastercam x5. Was wondering how I could tell it where to start. Seems like you just pick bottom left and top right and it does it how it wants. The rear of the pocket has a sloped wall but that doesn't seem to matter.
    Reply With Quote Reply With Quote
  2. 05-04-2015, 04:13 PM #2
    vuxuanhung88
    vuxuanhung88 is offline Registered
    Join Date
    May 2015
    Posts
    2

    Re: Plunge mill pocket

    same trouble
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. When would you plunge mill?
    By jsanchez177 in forum MetalWork Discussion
    Replies: 4
    Last Post: 02-10-2012, 03:14 PM
  2. Possible to setup a default Pocket Setting? i.e. Offset Pocket Out/.5" Roughing Mill/
    By 777funk in forum BobCad-Cam
    Replies: 1
    Last Post: 11-30-2011, 07:51 PM
  3. Separate plunge and mill feedrates
    By saabaero in forum SprutCAM
    Replies: 7
    Last Post: 02-22-2009, 08:41 PM
  4. X2 .250" 2 flute end mill plunge speed
    By mkenney in forum Benchtop Machines
    Replies: 2
    Last Post: 02-02-2009, 03:43 AM
  5. Pocket Plunge Placement
    By pzzamakr1980 in forum Mastercam
    Replies: 5
    Last Post: 04-07-2008, 01:48 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules