Those of you who have been following my posts over the last few months will know that I've taken on a somewhat ambitious project to totally retrofit a Bridgeport Series II Interact 4 with new drives and controls.

After in excess of 60 hours work, I have finally finished the wiring diagram.

I'd be greatful if anyone with a bit of knoweldge of CNC Retrofits, mach3, rutex produts , or electrics/electronics in general could have a quick look at my diagram and just check that it makes sense and I havent done anything stupid.

I'd rather solve problems now before the blue smoke.

Similarly, if anyone else is attempting a similar project, I hope this is of some use to you.