[RomaxxCNC]

Hi everyone,

We are pleased to announce the introduction of our new 3 axis CNC platform.

With many features including blistering rapid rates. Much more info here.

www.romaxxcnc.com

The website is still a bit rough around the edges.

A woodworking video magazine has also filmed an extensive article on it as well and soon to be released.

Thanks, Ron

RomaxxCNC

[InspirationTool]

Neat little machine.

What are you seeing for accuracy/repeatability?

-Jeff

[Switcher]

Nice looking, machine.

[Switcher]

I just downloaded a couple of your movies, very fast machine!

http://romaxxcnc.com/romaxxengrave.avi
http://romaxxcnc.com/romaxxpocket.avi

What kind of drives do you have?

Jerry


.

[RomaxxCNC]

Thanks for the compliments, we are very happy with the machine and it's performance.

To answer the inquiries:

Repeatability/ Accuracy? The machine pictured uses the encoder feedback to track axis position. We have done extensive testing and it will repeat to within +/- .002". The gantry is driven from both sides through one stepper motor via a line shaft equalizer. It is set up for two steppers if one wishes to add another. Our testing showed it was not needed. The stepper motors are 200 oz-in. The Nema 23 steppers are available up to 500 oz-in on the same mounting pattern. Rapids would be much higher. Approaching pick and place performance. Thats speculation though, it's not been tried.

Drive types? We are using Geckodrives. Of the drive types tested, they were the only one's capable of the high accelerations we were after. Although, we did not test every drive that is available.

Thanks, Ron
RomaxxCNC

[David Da Costa]

What is the availability of the machines.

Thanks

David

[RomaxxCNC]

Hi David,

We are finishing up a production run of machines and they will be shipping Thursday (10-12-06). Hopefully, We will have stock on a regular basis going foreward.

Thanks, Ron