[turkgeltz]

Very nice pictures!!!! And I like all the different ways you can do it! I'm trying out cutting a image in plexiglass at the moment to see how it comes out and I'm thinking about trying to carve out a image in ceramic tile (12x12). I don't know if anyone's tried that yet. I think I'm just use a sharpened carbide bit at high speed. Any good advice on it or would you perfer the damage report?

[High Seas]

Just finished laying a kitchen full of tile - and a marble counter top - water, LOTS of WATER. All my cutting was with carbide or diamond blades.
I didn't etch/carve anything - but there are a lot of finishing products available (best to always check good ole Harbor Freight first). Some folks have been engraving marble over on the Yahoo/Master5 group. Might be a hint or 2 there too.
:cheers: Jim

[turkgeltz]

Thanks, maybe I'll check it out! I'm only going to go about .015 to.020 deep. Probably only enought to break the ceramic coating, I think. Experimenting, you know make 3 or 4 pieces of trash and then learn something neat that can be done from it!

[foamcutter]

Check out this site www.luberth.com/plotter/ditwasplotter.htm I hope I copied that all down right. look down the links to Marty Harper 3d stone carving. may be some help there.

[ivsatin]

FROSTING OF GLASS PROFESSIONAL CREAM

https://www.youtube.com/watch?v=XOO8...ature=youtu.be