Hi,
I have been using a collet chuck with an HSK 63 back end and a 25mm multichange tool loaded into it. The collet is 24-25mm and I've tightened it as much as I can. When I use a spanner on the tip and apply some force I am able to turn the tool in the collet.
This doesn't seem right to me and I would have thought that it was not possible to turn a tool in a tightened chuck... or am I wrong?... I have dismantled the chuck assembly and given it a good clean in the thought that something may be preventing it from tightening properly but the same is possible after cleaning.
Could this indicate wear on the collet or something else.... I'm a bit reluctant to spin it in the CNC if it may "spin out".
Any advice would be great.
Mike