Ok, So I have a hitachi-seiki HT20 Lathe. Has the Fanuc 10 T control. In the mornings, when trying to turn the machine on, it takes 20+ trys of turning the control on and off to get it to turn the screen on. I do not believe it is a screen problem, but rather I/O or power supply issue. Since it has been getting colder, it takes more and more trys. Even once you get the screen to turn on, the standby light, or any of the LED's on the control next to the switches do not turn on. If once you get the machine to turn on, and run it for a half hour or so, and then turn it back and on again, the led's will illuminate when they are supposed to. You can still run the machine and zero return with the standby button pushed, and energized, even though the LED's do not come on. I have a parts machine I can pull parts from, but just not sure what part or parts to start swapping. Any ideas?