[dpot]

Hear is a glider caled bigBrother in dxf and is set out on a
1200 x 300 x 3mm Sheet of light ply, for the booms I used the top of fishing rods but 10mm carbon wood be beter,I made the fuz and wing first with all the raido moter and batrey installed and then fited the boom with the v taile to get the right center of ballence

sorry for that i forgot to explode the dwg before exporting and pergeeing
have a go at this there is sum gc for kcam with 0 offset with a 3mm router bit will cut on the line :stickpoke