Hello,
I just received some hy-div16n drivers, how should I wired them to my BOB?
DRIVERS
en-
en+
dur-
dir+
pul-
pul+
BOB
5v
GND
CK
CW
EN
Thanks
Hello,
I just received some hy-div16n drivers, how should I wired them to my BOB?
DRIVERS
en-
en+
dur-
dir+
pul-
pul+
BOB
5v
GND
CK
CW
EN
Thanks
I was able to wire the motors and drivers to my new bob i recently bought but now that i have everything wired up the z motor is to be weak to spin the lead screw, Do i need more power? i'm currently running a sp-150-24v or is it the cheap ebay step drivers
motors are nema 23
23hs22-2804s
Reason are the stepper drivers.
See this thread: TB6600 drive from EBAY
Open source CNC electronics and accessories:
http://users.skynet.be/ldt/CNC%20electronics/THB6064AH.html
check the gauge of your wire and make sure its shielded. Thin wire less data....like a hose pipe