I am trying to get a 8 pos. Miyano turret to index correctly after the Fuji drive was repaired by OSI in California. They claim that all parameters are correct. The realignment procedure is followed and correctly sets the tool number to 1. When a manual index is executed. The turret passes the stop position by about 10 degrees. After that all tool positions are off by the same amount. They sent a copy of the installed parameters but they were hand written and did not include any description. Can anyone help? A manual on the drive would be helpful.
Results 1 to 3 of 3
-
12-28-2014, 02:52 PM #1
Registered
- Join Date
- May 2005
- Posts
- 16
Miyano lathe with turret indexing problem.
-
12-28-2014, 03:26 PM #2
Registered
- Join Date
- Oct 2012
- Posts
- 87
Re: Miyano lathe with turret indexing problem.
What Model Miyano is it. Also what controller does it have?
Eg BNE34s
Alan
-
12-30-2014, 12:18 PM #3
Registered
- Join Date
- May 2005
- Posts
- 16
Re: Miyano lathe with turret indexing problem.
Model BND 34C, Fanuc OT
Reply With QuoteSimilar Threads
-
Miyano BNC-34t turret problem
By mr1 in forum FanucReplies: 13Last Post: 09-27-2021, 06:45 PM -
Miyano BNC-34C turret problem!!!
By rai in forum FanucReplies: 5Last Post: 05-03-2016, 03:01 PM -
1997 Miyano BND-34s3 Turret Not Indexing
By tight-fit-tools in forum DNC Problems and SolutionsReplies: 1Last Post: 11-06-2012, 08:38 PM -
Turret Indexing Problem SL4
By ndp in forum DNC Problems and SolutionsReplies: 11Last Post: 06-30-2009, 04:39 PM
Tags for this Thread
Posting Permissions
