Anyone have a Delta 10/20 Mill Installation manual?
Has anyone used it to program the machine parameters before?
Have a TREE 310 but now has a 325 processor board. The Z-axis on a 310 and 325 apparently used different ballscrews because in order for Z to move correctly I have to apply a 0.8 scale factor. In other words Z moves more than commanded so now at full travel (5.5") the control thinks it has only gone 4.4".
Any help is appreciated. Just need to change the parameter in the PROM but not knowing the address / etc. makes it hard. I can get to the PROM programming screen but that is as far as I can make it.
Kirk