Hello Everyone,

I'm new to the forum and new to the CNC world. I've built a CNC router and it runs pretty good. I'm still teaching myself Mach 3 as well as my drawing software. I do have a few questions. But for now I will only ask one. I'm at the point now where I want it more automated (ie spindle and vacuum on and off with g code). I've been searching for days to find the "right" answer to my question. I'm hoping I will get it here. It is regarding outputs on a Hobby CNC pro board. I realize now that there are not any. I would like to control router and vacuum from mach 3. I built a relay box with two SSR's I just need a signal now. I did come across a relay board from cnc4pc.com. What is the best solution to this problem? I did already ask this question in a general forum unaware there was a forum specific for hobby cnc.

Thanks,
Keith