[tspiszak]

Does anyone have a post processor for fusion 360 for mazak lathe with milling like sqt250 m? I tried post processor for integrex and the code is ok but I have to get rid of all b axis stuff and other codes. Any help modifying a post much appreciated.
Regards
Tomasz

Sent from my D5803 using Tapatalk

[The Engine Guy]

Tomazs

Can you put a copy of your post processor in a Zip file and upload it so someone can have a look at it, also Zip up some good code that can be used as an example.

Regards
Rob

[tspiszak]

Tomazs

Can you put a copy of your post processor in a Zip file and upload it so someone can have a look at it, also Zip up some good code that can be used as an example.

Regards
Rob

working programme.

(****MILLING MODE****)
(18 JUL 22 - 09:59)
(TIME 0:0:26)
G53M302(MAIN CHUCK)
G17 (X&Y PLANE)
G21 (METRIC)
G40 (COMP CANCEL)
G90 (ABSOLUTE)
M5
G28 U0 V0
G28 W0
M205
M212
M202
M200 (MILLING MODE)
G28 H0
N10 M1
(FINISH PASS)
(DUMMY FLAT)
(EFFECTIVE DIAMETER 10.)
(STOCK AMOUNT 0.)
T0101
M212
G0 C0.
G98 G97 S2546 M203
G17 UH
M211
G12.1
G0 Z10.
G0 X5. Y40. M8
G0 Z1.
G1 Z-20. F3820
G3 X0. Y45. I-5. J0. F764
G3 X-45. Y0. J-45.
G3 X0. Y-45. I45.
G3 X45. Y0. J45.
G3 X0. Y45. I-45.
G3 X-5. Y40. J-5.
G0 Z10.
G13.1
M205 M8
G28 U0
G28 W0 V0
M212
M202
M30
%