585,764 active members*
3,994 visitors online*
Register for free
Login

Thread: run from here issue

Results 1 to 3 of 3
  1. 02-12-2015, 12:02 AM #1
    Lethrahn
    Lethrahn is offline Registered
    Join Date
    Feb 2015
    Posts
    28

    run from here issue

    so today i was using the run from here command (r.f.h) and when i tried to set the line to run from the program froze for a second
    when it unfroze it was ~10000 lines too early
    does this every time i retry it
    its very annoying as the program is quite long
    Reply With Quote Reply With Quote
  2. 02-13-2015, 07:33 PM #2
    Lethrahn
    Lethrahn is offline Registered
    Join Date
    Feb 2015
    Posts
    28

    Re: run from here issue

    any new info would be greatly appreciated
    Reply With Quote Reply With Quote
  3. 02-26-2015, 10:54 AM #3
    RCaffin
    RCaffin is offline Member
    Join Date
    Jun 2010
    Posts
    4256

    Re: run from here issue

    Yeah, well, Gerry might well have better info, but I have never had any faith in set-line and rfh. Very iffy.

    Cheers
    Roger
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. DFX issue
    By BBchevy396_ in forum Rhino 3D
    Replies: 3
    Last Post: 08-28-2011, 03:42 AM
  2. Cambam issue or Mach 3 Issue??
    By tracyranson in forum CamBam
    Replies: 11
    Last Post: 07-11-2011, 04:03 PM
  3. VF3 issue
    By driver1234 in forum Haas Mills
    Replies: 9
    Last Post: 03-11-2010, 06:11 PM
  4. Help with selector switch wiring issue (***actually a motor issue***)
    By BEDFORD in forum Charter Oak Automation Support Forum
    Replies: 7
    Last Post: 04-07-2006, 09:19 PM
  5. THC Issue
    By Aldoseri in forum CamSoft Products
    Replies: 3
    Last Post: 01-31-2006, 11:33 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules