Hello,
I am not sure why Cambam calculats for my pocket operation not the right toolpath.
The problem is that i want to cut a pocket with a 6mm diameter tool. When i choose a step over of 0.6 Cambam generates a toolpath that
did not cut the whole "middle". Between two pathes there are 6.88mm distance ...
I will give you three examples:
0.6 step over (distance between the two lines in the middle is 6.88mm)
Attachment 268894
0.5 step over (distance between the two lines in the middle is ~2mm)
Attachment 268898
0.7 step over (distance between the two lines in the middle is 5.54mm)
Attachment 268896
So my question is: Why does Cambam does not add a toolpath in the middle like it does for step over 0.5? 6mm tool and 6.88mm distance between pathes?
Thank you!