[Nigel_B]

Hi All
Does anyone know of an Australian supplier of breakout boards?
Not just a set of terminals to connect to a D25 but an isolating board that stops the PC being cooked.
I know they are avalable from the States, but does anyone here have them?
Nigel

[belli]

Hi Nigel,

Not in Aus. but am happy to mail them if you wish. www.cncdirect.co.za

Regards
Greg

[Electramech]

Hi,

The only australian supplier of Breakout boards I have found so far is Oatley Electronics, who sell a kit K142A. It doesn't have Optocoupler isolation but there are two handy relays to use with a Spindle Motor or whatever. It's cheap too.

I have started designing a Circuit Board for a opto isolated breakout board, especially to use with Mach 3.

Cheers,

David

[port_huon]

You might try Ocean Controls, they sell a number of motor controllers and may have breakout boards as well.

http://www.oceancontrols.com.au/

Regards
Geoff

[jallitt]

I just ordered one of these from ocean controls.

KTA-192 1 AUD$ 35.00 AUD$ 35.00
Parallel Port
Interface card
asembled

Lets see how long it take to get from AU to NZ.

You might try Ocean Controls, they sell a number of motor controllers and may have breakout boards as well.

http://www.oceancontrols.com.au/

Regards
Geoff