[Leyland 472]

Help With TNCremoNt & machine parameters

Can one help we with setting up this software I am unsure what cable configuration is?

Also has any one got a set of parameters for the TNC 155B controller ?


Any help would appreciated, before I go mad !!!!!!!!!!!


Andy

[machintek]

I have a Bridgeport technican bulletin at the office about RS232 communications to a TNC but back then EZUTLS was used because it was a part of EZCAM. TNCREMO did not exist.
I have always used a laptop running a DOS version of PROCOMM to communicate to TNC, FANUC and Bridgeport controls. I need your email address to send you that bulletin.

George

[Adobe Machine]

Machintek: Thanks from a LOT OF US... I would just like to say THANK YOU.
I know that you take a lot of your time and effort to help those with Bridgeports, free of charge...People like you are what makes this a great, professional forum.

Adobe (old as dirt )

[Leyland 472]

Thanks any help would rely be good. My e-mail address is '[email protected]'

Regards Andrew

Have just downloaded your bulletin, thankyou for you help.