This is for Svenakela. I watched a video where you arrayed a toolpath then ran a command to repair group. I have the latest version of Madcam and it doesn't seem to have that command that I can see. Is there a way to accomplish this in the newer version? Thanks
Thread: Array toolpath
Results 1 to 3 of 3
-
02-26-2015, 12:00 AM #1
Registered
- Join Date
- Oct 2006
- Posts
- 51
Array toolpath
-
02-26-2015, 12:27 AM #2
Community Moderator
- Join Date
- Mar 2004
- Posts
- 1661
Re: Array toolpath
That's because you don't have to repair the group any longer. You can select a tool path, array it and all paths will be in the same path layer automatically.
I just did it with both a roughing tool path and a pocket operation.
-
02-26-2015, 02:01 AM #3
Registered
- Join Date
- Oct 2006
- Posts
- 51
Re: Array toolpath
Thank you for the quick response. I'll give it a try.
Reply With QuoteSimilar Threads
-
Eagle PCB array?
By stk2008 in forum PCB millingReplies: 5Last Post: 03-21-2011, 07:05 PM -
EnRoute Toolpath Array
By Gazza66 in forum EnRouteReplies: 1Last Post: 10-05-2009, 10:25 PM -
Pin array
By sp1nm0nkey in forum MastercamReplies: 1Last Post: 07-05-2009, 03:27 AM -
L10 cut array command
By RossMColquhoun in forum G-Code ProgramingReplies: 1Last Post: 03-05-2009, 01:59 AM -
Array with v20
By DEW in forum BobCad-CamReplies: 1Last Post: 11-21-2007, 12:50 AM
Tags for this Thread
Posting Permissions
