Is anyone running a MX4660 yet.
Would be interested in hearing their experiences with it
Is anyone running a MX4660 yet.
Would be interested in hearing their experiences with it
I've had one for a few weeks now. So far so good. Only issues I've had is a lack of information on the interwebs due to it being new to market. It uses the same SDM660 drivers as the MX3660 from what I've gathered.
I am 100% new to this whole CNC world, so I don't have anything to compare it to. I've paired it with the 320oz steppers from cncrouterparts and I'm happy with the setup. Again, I have nothing to compare it to.
I'm driving it with LinuxCNC, and for a complete newbie, I'd say that overall my experience in setting it up (both LinuxCNC and the MX4660) and using it has been very positive.
Im runing a mx4660 myself - Have you been able to wiring up the inputs 5 - 8?
What do you use for shunt resistor on the power side or do you use capacitor?
nothing, I asked someone (can't remember who) about it and said it wasn't really required in my setup..