[109jb]

I am working on a new project and am thinking about using an X2 head that can be purchased from Little Machine Shop. What I need to know are the dimensions of the head. I have attached a picture of the dimensions I need which are as follows.

A - Width of head casting
B - Height of Head Casting
C - Depth of head casting
D - Distance from rear of casting to spindle centerline

EDIT - I would also like the distance the spindle nose protrudes below the bottom of the casting.

I don't need exact measurements. Just a tape measure accuracy is good enough for what I need right now.

Thanks in advance.

John B.

[dang]

A - 3.47"
B - 4.35"
C - 5.27"

[109jb]

Thanks.

Would anyone have the other 2 dimensions?

D - Distance from rear of casting to spindle centerline

E - distance the spindle nose protrudes below the bottom of the casting.

Thanks again.

John B.

[Hack]

This drawing might help.

Spindle Drawing

Dan

[fusion_crank]

I was going to make a mill with a head like that too. I bought a mini lathe head off eBay. Since buying it, I have since been given a different headstock assembly. If you could use a MT3 spindle headstock I can make you a good deal on it.


Sent from my iPad using Tapatalk

[hoss2006]

Harbor Freight X2

Hoss