[dhardt]

To address the Periodic Maintenance Alarm

tec2008-30.pdf shows how to clear the alarm

tec2008-46.pdf shows how to set/change the times and add/remove line items

[dhardt]

B-Axis overhaul for an Old Style MX

MX2000
MX2500

[dhardt]

How to Reset the Home position on ANY Doosan Machine.

(Note: for the exact numbers for your exact machine, you will need the Instruction Manual (AKA: maintenance and specification manual)

This procedure shows how to gather all needed information and apply it correctly based on what hardware the machine has and the reason why the "Reset of Home" is needing to be done.

[dhardt]

How to maintain and calibrate the Q-Setter on an Lynx 220:

[dhardt]

I don't know how else to answer your PM: as it won't let me...So I'll try this reply to something that you posted.

In this thread is the "How to reference any Doosan machine"

Call 973-618-2461 if you need to discuss further.

[dhardt]

whats ur email I checked my settings and they r all good it says I can get pm from everyone

Darryl.hardt@doosanmt.com
It is in the footer of every post I have...

...and you have emailed me before...

[Maint_Tech]

Where can I find the procedure for replacing the clamp/unclamp solenoid on a Doosan LYNX 220 LM

[dhardt]

Where can I find the procedure for replacing the clamp/unclamp solenoid on a Doosan LYNX 220 LM

If you meant cylinder then this:
Attachment 429802

if you are asking for a procedure for "replacing the...solenoid" they don't exist within Doosan...

Here goes:

1. Verify the replacement is correct.
2. Take pictures and/or mark connections of previous unit.
3. Remove previous unit.
4. Install replacement unit.
5. Verify the connections are correct.

[dhardt]

How to adjust reference position for the Power Mate Manager controlled ATC and Magazine of a Doosan MX machine: