Hello All,

I have VCarvePro ver 7.5 and have built a gadget. The gadget lays out each side of the box joint on named layers and generates two (2) tool paths, one for each hand (side) of the box joint. I have added a help screen and a PDF to show how to config the material setup.

Please have a look and let me know your thoughts. I am looking for feedback on what I can add to the gadget.

Note:
I have add a mounting system to the end of my mill to hold the material in a vertical position. This will hold the material so that I can mill on the edge or end of the stock.

I am working on a Dovetail version and should have the first version out in two weeks. let me know if you would like to see that too.

Have a great day,
Jim in Houston Texas