[Andygraphy]

Hello Guys,

I just want to use a Endmill for drilling holes and inside turning. I just try to define a bore tool, it works for inside turning, but i i want to you it for drilling a hole with a "bore", i get a error for using the wrong tool type!? Partmaster told me that i need a end mill, a bore e.g. ... but i have a bore!? whats the problem.

thanks

[DICKEYBIRD]

Try defining a new boring tool and change its primary & included angles to 90 deg & -90 deg. Set your Hand & Approach to how you need them. Select that new tool number after completing the drill cycle and build your internal turning job from there. I think that will work.

[Andygraphy]

Hi,

Ok i tried it again, and now it works... i dont know why but it works. I has defined my end mill as a bore tool.

but i have another problem now... i want do dril/turn inside this pulley. the smallest diameter is 8mm, the bigger one 10mm (picture)

my endmill has a 4mm diameter, so the maximum deep of cut is 2mm. is my defined tool correct?

Because i got this Code (working in Dia mode):

% Rolleextra.NC
N10 G54 K0.00
N15 M60 D0.0 L0.0
N20 G90
N25 G21
N30 Z70.0 X130.0 M09
N35 M6 T18
N40 S300 M03
N45 G00 G40 X0.0 Z3.0
N50 G01 Z-12.0 F50.0
N55 G00 Z3.0
N60 G00 Z0.0
N65 G01 X-1.741
N70 G01 Z-12.0
N75 G00 X0.259 Z-11.0
N80 G00 Z0.0
N85 G01 X-3.482
N90 G01 Z-12.0
N95 G00 X-1.482 Z-11.0
N100 G00 Z0.0
N105 G01 X-5.223
N110 G01 Z-12.0
N115 G00 X-3.223 Z-11.0
N120 G00 Z0.0
N125 G01 X-6.963
N130 G01 Z-12.0
N135 G00 X-4.963 Z-11.0
N140 G00 Z0.0
N145 G01 X-8.704
N150 G01 Z-2.55
N155 G01 X-8.2
N160 G03 X-8.0 Z-2.65 I0.0 K-0.1
N165 G01 Z-12.0
N170 G00 X-6.0 Z-11.0
N175 G00 Z0.0
N180 G01 X-10.445
N185 G01 X-10.2
N190 G03 X-10.0 Z-0.1 I0.0 K-0.1
N195 G01 Z-2.55
N200 G01 X-8.704
N205 G00 X-6.704 Z-1.55
N210 G00 X-3.604 Z0.0
N215 G00 X0.0
N220 G00
N225 M30
%

[Andygraphy]

but i get an diameter of 11,55mm and 13.55mm .....whats wrong?