Hi everyone, Anyone know which Post Processor I should use for my new Centroid retorfit Mill? It's the DC-AIO w/ CNCV11 software. Just not sure what to do there?
Hi everyone, Anyone know which Post Processor I should use for my new Centroid retorfit Mill? It's the DC-AIO w/ CNCV11 software. Just not sure what to do there?
According to Centroid, Use anything Fanuc 0m also, IF you take a PPR out as g-code and load it up, if the CNC11 software can load and graph it, It'll cut it. Directly from Support. My only issue is to see if I can figure out which PPR is for Fanuc0m tgif