While troubleshooting a different (but possibly related issue which is 'randomly, during manual movement / orienting / running a job, the Z Axis slams down into the table'), I had removed the bit / tool, and after orienting, I move the spindle to the left (towards the keyboard..) and then with the boot fully lowered, moved the z down until it reaches the table. Once it makes contact, Z moves back up a tiny bit and throws error "Z AXIS".

I have two identical tables and the other one does not freak out once it reaches the table surface. Unfortunately I do not have a 3rd table to verify that either behavior is normal and the manual does not list this error occurring in this manner. I would assume the z axis should be fine with making contact with the table while manually moving it using the keyboard.

Also, when my error occurs, the AMP LED becomes lit on the top board of the Electrical Cabinet.

Can anyone help me with this?