[pop28]

hey all
i have morbidelli u550stc machine and loss all backup data in ramdisk because my battery dead, after that i restore plc and parameter all original data on tria6500 but still have problem with z axis when i start manual cycle its work good if i touch any function keys the z axis was falling down very fast to reach the limit switch i check the air pressure is good about 7 bar..
please any one help me

thanks alot

[pipoligiuseppe]

I can help you. I have all the software and I can repair it.

[pop28]

Dear sir
Thank you for reply to me can we talk on any chat ...
Best regards
Ahmed

[pipoligiuseppe]

oh yes sir, you can find me on G+ at the following address [email protected]